欢迎访问北京鸿达天矩试验设备有限公司网站

返回首页|联系我们

全国统一服务热线:

13699126950

产品中心您当前的位置:首页 > 产品中心 > > 恒温恒湿试验箱 > HT/HS-500专业恒温恒湿试验箱

基础信息Product information

产品名称:专业恒温恒湿试验箱

更新时间:2017-10-24

访问次数:415

产品简介:

专业恒温恒湿试验箱结构特点:
恒温恒湿试验箱箱体采用数控机床加工成型,造型美观大方,并采用无反作用把手,操作简便。内箱采用进口高级不锈钢(SUS304)镜面板,外箱采用(SUS304)拉丝不锈钢板或优质冷轧钢板喷塑,增加了外观质感和洁净度。并设有大型观测视窗附照明灯保持箱内明亮,且利用发热体内嵌式钢化玻璃,随时清晰的观测箱内状况。

产品特性Product characteristics

专业恒温恒湿试验箱安全保护系统:

Safety protection system of professional test box with constant temperature and humidity:

无熔丝开关,防干烧装置,极限高低温保护,温度偏差报警,缺相、逆相、短路、漏电保护。

No fuse switch, anti dry burning device, the limit of high and low temperature protection, temperature deviation alarm, lack of phase, reverse phase, short circuit, leakage protection.

恒温恒湿试验箱运行控制系统:

Operation control system of constant temperature and humidity test chamber:

(一)加热系统:

(a) heating system:

1. 台式恒温恒湿试验箱采用鳍片散热管形镍铬合金不锈钢电加热器,升温快使用寿命长。

1 bench test box with constant temperature and humidity by fin radiating tube shaped Ni Cr stainless steel electric heater, fast temperature rise and long service life.

(二)风路循环系统:

(two) the wind road cycle system:

1.采用多翼式离心送风机强力送风循环,避免任何死角,可使测试区域内温湿度分布均匀。

1 using the multi wing centrifugal powerful air circulation fan, to avoid any dead end, can make the test area temperature and humidity distribution uniformity.

2.风路循环出风回风设计,风压、风速均符合测试标准,并可使开门瞬间温湿度回稳时间快。

2 wind road cycle wind return air design, wind pressure, wind speed are in line with the test standard, and can make the door instantaneous temperature and humidity stabilized time soon.

3.采用可上、下、左、右调整导风板,以保证温、湿度均匀分布。

3 using the upper and lower, left and right, to adjust the wind guide plate, in order to ensure uniform distribution of temperature, humidity.

(三)加湿系统:

(three) the humidification system:

1.加湿:全独立系统,外置隔离式全不锈钢浅表面蒸发式加湿器,通过加热形成湿蒸气加湿,通过探头检测湿度。

1 humidification: full independent system, external isolated all stainless steel shallow surface evaporation type humidifier, formed by heating the wet steam humidifier, through the probe to detect humidity.

2.供水:隐藏式水箱供水,小水泵自动抽水到加湿桶,可回收余水.节水降耗。

2: the hidden type water tank water supply, automatic pumping to the humidifying barrel small water pump, water and energy saving Recyclable residual water.

升温、加湿系统完全独立可提高效率,降低测试成本,增长寿命,减低故障率。

Warming, humidifying system compley independent can improve efficiency, reduce testing cost, increase in life expectancy, reduce failure rate.

专业恒温恒湿试验箱产品用途:

Constant temperature and humidity test box product use:

台式恒温恒湿试验箱是航空、汽车、家电、科研等领域必备的检测设备,用于测试和确定电工、电子及其他产品及材料进行恒定试验的温湿度环境变化后的参数及性能。

Bench test box with constant temperature and humidity is the necessary testing equipment, autos, household appliances, aviation and other fields of scientific research, for testing and determining parameters and performance test of temperature and humidity environment constant electrical, electronics and other goods and materials after the change.

专业恒温恒湿试验箱结构特点:

Professional test box with constant temperature and humidity structure characteristics:

1.台式恒温恒湿试验箱箱体采用数控机床加工成型,造型美观大方,并采用无反作用把手,操作简便。

1 bench test box with constant temperature and humidity box adopts CNC machining molding, beautiful appearance, and the handle with no reaction, simple operation.

2.内箱采用进口高级不锈钢(SUS304)镜面板,外箱采用(SUS304)拉丝不锈钢板或优质冷轧钢板喷塑,增加了外观质感和洁净度。

2 inner box adopts imported stainless steel (SUS304) mirror panel, outside the box (SUS304) by wiredrawing stainless steel plate or high-quality cold-rolled steel plate spray, increase the appearance of texture and clean.

3.设有大型观测视窗附照明灯保持箱内明亮,且利用发热体内嵌式钢化玻璃,随时清晰的观测箱内状况。

3 a large observation windows attached lamp keeping of bright, and the use of a heating body embedded toughened glass, clear observation box status at any time.

4.箱体左侧配直径25mm或50mm或100mm的测试孔,可供外接测试电源线或信号线使用。

4 the left side of the box body with diameter of 25mm or 50mm or 100mm test hole, can be used for external test power line or signal line.

5.保温材质采用高密度玻璃纤维棉,厚度为80mm。门与箱体之间采用双层耐高低温之高张性密封条,以确保测试区的密封。

5 insulation material with high density glass fiber cotton, thickness of 80mm. Between the door and the box body adopts the double-layer high temperature high tension seal, in order to ensure the sealing test area.

6.设有独立限温报警系统,超过限制温度及自动中断运行,保证试验安全进行不发生意外。

There is a 6 independent limit temperature alarm system, exceeds the limit temperature and automatic interrupt operation, ensures the test safety is no accident.

7.加湿系统管路与控制线路板分开,可避免因加湿管路漏水发生故障,提高安全性。

7 separate humidification system pipeline and a control circuit board, can avoid the failure by the humidifying pipe leakage, improve safety.

8.水路系统管路电路系统采用门式开启,方便维护和检修。

8 water system piping circuit system adopts the door open, easy to maintain and repair.

专业恒温恒湿试验箱控制器:

Professional test box with constant temperature and humidity controller:

1. 台式恒温恒湿试验箱控制器采用全进口LED数显按键显示屏,英文界面(韩国TEMI300)或液晶触摸显示屏,中英文切换界面(韩国TEMI880),

The controller 1 bench test box with constant temperature and humidity imported LED digital key press display, English interface (TEMI300 Korea) or LCD touch screen, Chinese English switch interface (TEMI880 Korea),

或进口日本“OYO"数显触摸按键温度湿度控制仪。温湿度控制可直接显示,摒弃原有温湿度相对照的缺陷。

Or the import of Japanese "OYO" digital touch keys to the temperature and humidity control instrument. Temperature and humidity control can be displayed, abandon the shortcoming of the original temperature and humidity contrast.

2.资料及试验条件输入后,控制器具有锁定功能,避免人为触摸而改变温度值。

2 data and test conditions after input, the controller has locking function, avoid human touch and change the temperature value.

3.控制器具有P.I.D自动演算的功能,可将温度湿度变化条件立即修正,使温度湿度控制更为精确稳定。

The 3 controller with P.I.D automatic calculation function, changes in temperature and humidity conditions can be corrected immediay, so that the temperature and humidity control is more precise and stable.

4.可选配打印机。能打印记录设定参数和扫描出温度湿度变化曲线。4~200mA标准信号。

4 optional printer. Can print record setting parameters and scan curve changes in temperature and humidity. 4~200mA standard signal.

留言框

  • 产品:

  • 留言内容:

  • 您的单位:

  • 您的姓名:

  • 联系电话:

  • 常用邮箱:

  • 详细地址:

  • 省份:

  • 验证码:

    请输入计算结果(填写阿拉伯数字),如:三加四=7

上一篇:HT/GDWJ-150交变高低温试验箱

下一篇:UV-A紫外老化试验箱专用灯管

联系人:凌先生13522172738

邮箱:bjhdtj@163.com

地址:北京市朝阳区小武基97号

©2020 北京鸿达天矩试验设备有限公司 All Rights Reserved.   备案号:京ICP备09060791号-1  管理登陆  技术支持:仪表网  sitemap.xml

在线客服 联系方式 二维码

服务热线

86-010-57926031

扫一扫,关注我们